On weekends, bringing an aluminum frame marquee to camp in the wild is a very pleasant thing. Here is how to build a simple aluminum frame marquee:

1. First choose the camp, and lay the aluminum frame marquee's inner tent on the ground (usually the inner tent, but there are also some who first set up the outer tent and then hang the inner tent. The principle is to wear the layer of the tent pole. ), the nail bag, pole bag and other accessories wrapped with aluminum frame marquee are put aside first.
2. Take out the folded tent pole, butt it, straighten it section by section, and connect it into a long pole
3. Pass the long fiber rod into the aluminum frame marquee (also called pipe). Some double-layer tents are internally hung, and the hook is hung on the fiber rod. There are several poles to wear at the same time.
4. Insert one end of the fiber rod into the eye hole or the needle ring at the bottom corner of the aluminum frame marquee (some aluminum frame marquee uses a needle ring, each has its own advantages), and then to the other end (diagonal), hold the rod in one hand , Holding the bottom corner of the aluminum frame marquee in one hand, slowly arch the rod. After the aluminum frame marquee is propped up, insert the rod into the eye or the needle ring at the bottom corner.
5. The last thing is to hang up the external account, open the external account, and cover it on the internal account. It should be noted that the doors of the inner and outer tents must face one direction, and the four corners should be hung on the four corners of the inner tent (you can find the hanging place near the position of the tent pole), and some are for the outer tent. The four corners are also nailed near the four corners of the inner tent, and see if there are hanging loops on the outer tent.
The outer tent should also be tight and there is no place where it is attached to the inner tent. In this way, the inner tent will not get wet, and due to breathing, a layer of dew or frost will form on the outer tent in the morning, and it will not be touched or touched. Wet inner tents, but there are also bad aluminum frame marquee frosts that will settle into the inner tents. In that case, if you wake up early, it will snow in the aluminum frame marquee. Of course, the weather is good, and it’s quite comfortable without the outer tents. .
6. Supplement: There are some ropes on the tent, which are used to reinforce the aluminum frame marquee. Generally, you don't need to pull it if there is no strong wind. If you don't worry, you'd better pull it up. Use ground nails. Pull several ropes evenly.